The composition of the outdoor advertising light box is very simple. It is composed of the light body of the advertising light box (commonly used with glass plate or PVC layout), plus reverse or organic words or self-adhesive words, etc., with corner iron frame. Now I would like to share with you the material selection and production process of outdoor advertising light box.
1. Design: according to the design requirements of customers, make the size, color, primary and secondary arrangement of font, change of graphics and text, horizontal and vertical arrangement of light box. In addition, it depends on the installation site.
2. Angle iron: it can be processed by itself if conditions permit, but it can be processed outside if conditions permit.
3. Wood: 2 × 2 cm square timber for nailing.
4. Keel: generally hexahedron. Material: 20 × 20 or 30 × 30。
5. Aluminum material: aluminum alloy material for land use cabinet, with the same height, width and length. Saw into 45 degree angle and connected with plug-in.
6. Cutting: length and width of each four, length and width minus 0.5cm = wood length. Two end saw 2 × 1 tenon, apply white latex paste and then nail. Thickness dimension minus two material thickness + 0.5 = thickness length. Then apply white mastic and nail it.
7. Installation lamp: generally use two or three fluorescent tubes. 40W1.2 meters long tube, with more than 1.3 meters light box. The 30W lamp is 0.9m long and is used in the lamp box above 1.1m. The thickness is generally 20-25 cm.
1. Design: according to the design requirements of customers, make the size, color, primary and secondary arrangement of font, change of graphics and text, horizontal and vertical arrangement of light box. In addition, it depends on the installation site.
2. Angle iron: it can be processed by itself if conditions permit, but it can be processed outside if conditions permit.
3. Wood: 2 × 2 cm square timber for nailing.
4. Keel: generally hexahedron. Material: 20 × 20 or 30 × 30。
5. Aluminum material: aluminum alloy material for land use cabinet, with the same height, width and length. Saw into 45 degree angle and connected with plug-in.
6. Cutting: length and width of each four, length and width minus 0.5cm = wood length. Two end saw 2 × 1 tenon, apply white latex paste and then nail. Thickness dimension minus two material thickness + 0.5 = thickness length. Then apply white mastic and nail it.
7. Installation lamp: generally use two or three fluorescent tubes. 40W1.2 meters long tube, with more than 1.3 meters light box. The 30W lamp is 0.9m long and is used in the lamp box above 1.1m. The thickness is generally 20-25 cm.
